Galvanized steel is generally in the low-carbon steel outer layer of the zinc-plated, galvanized layer is generally 20um thick. The melting point of zinc is 419 °C, bp 908 °C or so. In welding, the zinc melted into the liquid floating on the surface or in the root of the weld pool position. Zinc has a greater degree of a solid solution of iron, zinc, and liquid etching along the grain boundary deep weld metal, the low melting point of zinc to form a "liquid metal embrittlement." Meanwhile, zinc and iron can form brittle intermetallic compound phases of the weld metal of these brittle plastics reduction in the tensile stress and cracks. If the welding fillet welds, especially the T-joint fillet most prone to penetrate the cracks. When welding galvanized steel, a bevel edge surface and a zinc layer under the action of the arc heat, oxidation, melting, evaporation, and even volatile white smoke and steam, can easily cause weld porosity. Due to oxidation and the formation of ZnO, the high melting point of about 1800 °C or more, if the welding process parameter is too small, will cause slag ZnO, simultaneously. Since Zn is a deoxidizer. Produce FeO-MnO or FeO-MnO-SiO2 slag melting oxides. Second, because the evaporation of zinc, a large amount of white smoke evaporation, stimulates the human body, with harmful effects, therefore, necessary to weld galvanized layer of polishing off.
Galvanized steel welding preparation and the general low-carbon steel are the same, you need to pay attention to seriously handling groove size and the nearby zinc coating. To weld penetration, beveling size should be appropriate, generally, 60 ~ 65 °, to leave a certain gap, is generally 1.5 ~ 2.5mm; zinc in order to reduce the penetration of the weld, the weld before, the groove may be galvanized layer clear later welding. In actual supervision, using a centralized hit groove, leaving a blunt edge technology for centralized control, two welding processes, reducing the possibility of lack of penetration. Welding galvanized steel pipe should be based on a matrix material selection, and general ease of low carbon steel due consideration, the choice of J422 is more common.
Welding techniques: the first layer of the multi-layer welding weld seam, try to make it melt the zinc layer vaporization, evaporation, and escape the weld, which can greatly reduce the liquid zinc remaining in the weld. In fillet welding, the same as in the first layer makes the molten zinc vapors, evaporation and escape the weld, which is shifted forward end portion of the first electrode of about 5 ~ 7mm, when the zinc layer melted and then continues to move back to its original position welding. Horizontal and vertical welding again, if using short-slag welding, such as J427, tend to be small undercut; roundtrip transportation is the front and rear of technology, but also can be non-defective weld quality.
Cangzhou Shenlong Pipe Manufacturing Co., Ltd. cooperates with Baosteel and Baogang to produce large-caliber seamless steel pipe, straight-seam welded pipe, spiral steel pipe, and pipe fittings. The products comply with API, ASTM, DIN, BS, and JIS standards, and can accept SGS, BV, and other inspections. The products are used in oil, natural gas, bridge, water conservancy, and other large-scale projects, which are worthy of trust.