HIGH-FREQUENCY WELDING is a welding process in which the heat source used to melt the joining surfaces is obtained from high-frequency (HF) alternating current (ac) resistance heating.
Adjusting the amount of pressing the squeeze roll is maintained across the weld flush with the opening angle of 7 degrees or less, the gap control between 1-3 mm. If the Weld control is too large, it may appear poor welding, weld cracking produce incomplete fusion, or the weld control is too small, due to the excessive heat, the weld is likely to cause burning, molten metal splash, the build-up is too large, affecting the quality of welding. (Splatter reasons: melt extrusion tube side, the internal pressure is greater than the surface of the weld steam pressure)
Induction coil placement should be in the same center line pipe, induction loop front roll center line distance from the squeeze, squeeze rollers under the premise does not burn, depending on pipe size as close, too far away when the heat affected zone width, weld strength will decrease. Coupled induction coil more tightly as possible, the selection of a single circle should be equal to the width of the induction coil pipe diameter. Optional lap or two laps great impact on high-frequency oscillation frequency and output efficiency.
Impedance is a group or a special magnet whose cross-sectional area of 70% attributable to the inner diameter of the steel pipe section. Its role is to strengthen the electromagnetic induction, eddy currents concentrate the heat weld edges. Sometimes adding some magnets outside the weld, can also play a supporting role. Magnet permeability on temperature is large, the lower the temperature the higher the permeability. The magnet should be placed in the heating section V-zone, squeezing the front roll center position, the position of the magnet, and the magnetic permeability of welded directly affect the efficiency and weld quality.
High-frequency power input to the heat pipe weld area is called the input of heat, lack of heat input welding speed is too fast, can not reach the edge of the pipe welding temperature, the formation of incomplete fusion or penetration of the crack but excessive heat input when welding speed is too slow, too prone to burning, so that the weld breakdown, causing metal splash, the formation of pores. By adjusting the speed of the high-frequency voltage or welding method, and the size of the control input of heat, the steel pipe weld neither appears nor appears incomplete penetration welding wear phenomenon, reaching the welding quality requirements.
Cangzhou Shenlong Pipe Manufacturing Co., Ltd. cooperates with Baosteel and Baogang to produce large-caliber seamless steel pipe, straight-seam welded pipe, spiral steel pipe, and pipe fittings. The products comply with API, ASTM, DIN, BS, and JIS standards, and can accept SGS, BV, and other inspections. The products are used in oil, natural gas, bridge, water conservancy, and other large-scale projects, which are worthy of trust.