The length of the metal pipe is cut according to the requirement. Cutting tools have a grinding wheel piece cutting machine (also known as a toothless saw), hand saw, cutter, and other hand tools.
It is suitable for cutting metal pipes or metal profiles, especially bulk cutting processing is the most economic. The pipe cutting length you need should be determined before and draw a good cutting line. The pipe cutting machine before cutting the jig should be fixed firmly. Machine starts, press the grinding wheel slowly, not slam the rapid or too much pressure, so as not to burst grinding wheel accidents.
Saw blade teeth should point to the thrust direction, saw blade to tighten, not wobble. Operation when the pressure pipe clamp fixed on the console (console height was about lm), then firmly push and pull, can one-man operation, but also the two with the operation. To prevent heat and maintain lubrication can be made Jukou drip oil. No matter use mechanical or hand according to the cutting all wrong or feathered a cut section level off is smooth. Research may not be in slit fold truncation.
It is the use of rollers with a sharp knife, make 3600 the card on the pipe rotation, tighten the top wire while rotating the hob until it gradually into the top pipe cut off. In this way cutting metal pipe, the pipe will tilt the tube wall, not only reducing the tube diameter but also making the pipe wall is not smooth, damage to the conductor. Under normal circumstances should not be taken in cutting metal pipes. When used, if necessary, must be cut diameter steel pipe with a round file level, so that the pipe diameter and the diameter of the same incision.